Klarstein BLANCA Mode D'emploi page 21

Installation
This product is intended for flat wall mounting. Before mounting, make sure that the floor
and wall are flat and that the frame is flush.
1. Mark the position of the holes for the supplied wall brackets on the back of the
fireplace with a pencil.
2. Drill small holes with a small drill (2 mm) to prevent the MDF board from splitting
when the screws are inserted.
3. Attach the two wall brackets to the rear of the fireplace. Use the two small screws
supplied.
4. Place the fireplace against the wall and mark the position of the wall brackets with a
pencil. Then set the fireplace aside.
5. Drill the holes with a 6 mm drill bit and insert the dowels.
6. Put the fireplace back against the wall and fix it with the supplied long screws.
wall brackets
small screws
EN
21