Functional Description Of The Equipment; Tips And Needles Kits - Sagola 4100 XTREME Manuel D'utilisation

· If sagging occurs, this is due to the fact that the amount of product to be applied is excessive for
the air pressure used, that the viscosity is not correct or the application speed is not adequate.
Decrease the amount of product, adjust its viscosity or increase the application speed until the
required finish is obtained.
The spraying width (spraying pattern) obtained will depend on the air nozzle used. If nozzles are
required for other applications, contact the Technical Service of SAGOLA S.A.
The size or amplitude of the spraying pattern can be modified with the spray width regulator, by
turning the control anticlockwise to increase this or clockwise to reduce this.

7. Functional Description of the Equipment

The SAGOLA gun model 4100 Xtreme PD or Gotele can be used for spraying any high viscosity
product or highly abrasive and high micronage products, used widely in the Construction, Industry
in general, structural, etc.
Compressed air for spraying is connected to the air input connector under the gun grip.
The product to be applied is placed in the pressure tank (hereinafter Pressure Pot) or using a
pressure pump. From here it flows through a hose to the fluid tip and is them mixed with spraying
air in a way that can be controlled from outside the air nozzle.
When the trigger is pulled back to the first position, it engages the air valve stem, opening this and
allowing air to flow through.
When the trigger is pulled back fully, the product needle is retracted, allowing the product to flow
out. This is then sprayed in the form of a fan.
When the trigger is released, the needle returns to its initial position, first closing off the product
outlet and then the air valve and application stops.

8. Tips and Needles Kits

SAGOLA S.A. supplies Nozzle Kits and Tip and Needle Kits of different sizes for a variety of
different applications. In order to replace these, proceed as follows:
With the gun fully depressurised, remove the air nozzle.
Remove the product regulator with the spring and the spring stop and extract the needle to be
replaced. Remove the tip with the wrench supplied.
Fit the new tip and tighten. Now fit, in this order, the new needle, the spring and spring stop and
the product regulator. Lastly, fit the appropriate air nozzle.
There are Tip + needle Kits:
ø 2.20
ø 2.80
INOX
ø 3.20
ø 6.00
Gotelé PD
ENGLISH