See Section 14.3 Network for detailed network configurations.
You can set the network connection at the first start or later.
•
Press
(On/Off) to enter standby mode. The time, date and active alarms are shown on
the display.
•
If you have set up the network connection and use the DR690CD again within the network, the
connection will be established automatically. If you would like to change the network, call up
Settings to change the corresponding connection.
•
Enter the network password using the keypad on the remote control or via ▲ and ▼. If the
desired character is displayed, press ► to navigate to the next entry. At the end of the input,
press OK to confirm. Alternatively, press ◄ to navigate to the previous entry.
English
33