Room Thermostat - Sovelor MASTER CED 2 Serie Manuel D'utilisation Et De Maintenance

6.3. SWITCHING THE HEATER OFF:
en
it
6.3.1.
de
6.3.2. Disconnect the heater from the mains
es
electricity (SEE FIG. 6).
fr
nl
technical service center)
pt
(SEE FIG. 7)
da
HAVE TO BE RESTORED WITH WEAR OF
THE HEATER.
7.1.
no
to identify the correct pressure (Bar - PSI -
sv
kPa) of your heater.
7.2. Remove
pl
manometer connection (A).
7.3. Assemble the manometer (not supplied,
ru
cs
7.4. Switch the heater on.
7.5. Act on the regulation screw by turning it
hu
clockwise to increase the pressure and anti-
sl
clockwise to decrease it (B).
7.6. Remove the manometer and restore
tr
the screw/cap (A).
hr
8. CLEANING THE TANK FILTER
lt
(SEE FIG. 8)
lv
et
8.1. Remove the cap (A) from the tank.
ro
8.2.
8.3.
sk
paying attention not to damage it.
8.4.
bg
8.5. Close the cap (A).
uk
bs
el
zh
FOLLOWED.
9.1. Empty the fuel tank (some models have
a draining cap on the bottom of the tank. In
this case, remove the drain cap and empty
the fuel).
9.2. If the presence of residues is noted,
pour clean fuel into the tank and drain off
again.
the screw/cap of
9.3. Close the tank cap and/or the draining
cap and dispose of the fuel appropriately
according to the Standards in force.
9.4. In order to keep the heater in the best
way possible, it must be kept on a level
surface to prevent the escape of fuel and in
a dry place away from any possible external
threats.

10. ROOM THERMOSTAT

REMOTE ROOM THERMOSTAT:
(SEE FIG. 9)
For models preset for remote room thermostat,
remove the cover connected to the heater
(A), connect the thermostat (B) (optional)
and set the desired room temperature. The
room thermostat completely turns off the
the heater once the set temperature has been
reached. If the temperature drops below the
set temperature, the heater will automatically
turn itself on again.
THERMOSTAT INSTALLED ON THE
CONTROL PANEL:
(SEE FIG. 10)
For models with room thermostat installed on
the control panel, when the knob (B) is turned
display (A) for a few seconds, after which the
display shows the room temperature. When
the knob (B) is turned completely to the right,
heater works continuously.
REMOTE ROOM THERMOSTAT AND
ROOM THERMOSTAT INSTALLED ON THE
CONTROL PANEL:
(SEE FIG. 9-10)
For models preset for remote room thermostat
and room thermostat installed on the control
panel, remove the cover connected to the
heater (SEE A FIG. 9) and connect the
thermostat (SEE B FIG. 9) (optional). For
correct heater operation, completely turn the
knob to the right (SEE B FIG. 10), the display
the desired temperature on the remote room
thermostat.