Troubleshooting; Operation - Whirlpool WRF767SDHV Guide D'utilisation Et D'entretien

TROUBLESHOOTING

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a
service call, refer to the warranty page in this manual, visit www.whirlpool.com/product_help.
In Canada, visit www.whirlpool.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.

Operation

PROBLEM POSSIBLE CAUSES
The refrigerator Check electrical supply
will not operate
Check controls
New installation
Refrigerator control is in Showroom
mode (on some models)
32
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
SOLUTIONS
Plug the power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Make sure there is power to the outlet. Plug in a lamp to see if the outlet
is working.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Make sure the controls are turned on. See "Using the Control(s)."
Allow 24 hours following installation for the refrigerator to cool
completely.
NOTE: Adjusting the temperature controls to the coldest setting will not
cool either compartment more quickly.
If the refrigerator is in Showroom mode, cooling is turned off and
"Showroom" will be illuminated on the control panel. See "Using the
Control(s)" for more information.
In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 – 6750 Century Ave.
Mississauga, Ontario L5N 0B7