Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Place 8" round adapter on top of power pack
and secure with (4) M4x8 screws. Connect 8"
round duct work to 8" round adapter.
B
3. Place cap over threaded end of remote blower
wiring and secure by turning clockwise.
A: Ground wire screw
location (inside)
A B
A
5. Secure green ground wire from remote
- elec k/o
blower wiring to ground screw located
B
- ext blower k/o
inside the power pack
NOTE: For instructions on installing remote blowers, please refer to the CBE-1000 or PBN-1000A
manuals included in the blower packaging and on our website: www.zephyronline.com
2. Install threaded end of remote blower wiring
through external blower wiring knock out (B)
located in junction box on top of power pack.
A
- elec k/o
B
- ext blower k/o
4. Connect 6 pin male connector from blower
wiring to 6 pin female connector in the power
pack. (plug is located inside the power pack
protruding from the white control board box).
CBE-1000 / PBN-1000A: WIRING DIAGRAM
A
Remote Blower
Wiring Box
(hood)
12
www.zephyronline.com
B
A B
White (common)
Black (high)
Junction Box
Blue (med)
(Remote Blower)
Red (low)
Green (ground)
Publicité
Table des Matières
