Test Light Instructions; Battery - SportDOG X Serie Manuel D'utilisation

TEST LIGHT INSTRUCTIONS

Should you need to test your system, follow these instructions:
1. Turn on the Collar Receiver.
2. Hold the Test Light Contacts to the Contact Points.
3. Press a Static Stimulation Button on the Remote Transmitter.
4. The Test Light will flash.
NOTE: At higher static stimulation levels, the Test Light will flash brighter.
5. Turn off the Collar Receiver.
Save the Test Light for future testing.
NOTE: If the Test Light does not flash, recharge the battery and re-test. If the Test Light still does not flash,
contact the Customer Care Centre.

BATTERY

This system operates on two Li-Ion battery packs. Only replace with battery received from calling the
Customer Care Centre.
• Batteries should never be removed from the battery compartment for charging.
• The rechargeable Lithium Ion (Li-Ion) batteries are not memory sensitive, do not require depletion before
charging, and cannot be over charged.
• The batteries come partially charged from the factory, but will require a full charge before the first use.
• When storing the unit for long periods, remember to regularly give batteries a full charge. This should be
done once every 3 to 4 months.
• You should expect hundreds of recharge cycles from your batteries. However, all rechargeable batteries
lose capacity over time relative to the number of recharge cycles they experience. This is normal. If your
operating time drops to half of the original life, contact the Customer Care Centre to purchase a new
battery.
• The batteries should last for a period of 3-5 years. When a battery needs replacement, you can order a new
pack by calling our Customer Care Centre. Please do not open the Collar Receiver or Remote Transmitter
until you have received the replacement.
Separate collection of spent batteries is required in many regions; check the regulations in your area before
discarding spent batteries. Please see below for instructions on how to remove the battery from the product
for separate disposal.
AT END OF PRODUCT LIFE, USE THESE BATTERY REMOVAL INSTRUCTIONS FOR FINAL DISPOSAL
(DO NOT OPEN THE COLLAR RECEIVER OR REMOTE TRANSMITTER UNTIL YOU HAVE RECEIVED THE
REPLACEMENT).
1. Using a #1 Phillips screwdriver for your Remote Transmitter and/or a 3/32 Hex Key for your Collar
Receiver, remove the case screws.
2. Remove the case back or cover.
3. Remove the old battery pack.
These instructions are not valid for repair or battery replacement. To avoid invalidating your warranty,
please call the Customer Care Centre for help in replacing your battery with one that is specifically approved
by Radio Systems Corporation.
For a list of patents protecting this product, please visit: www.radiosystemscorporation.com/patents
WWW.SPORTDOG.COM 19