Change Id Codes; Accessories - SportDOG X Serie Manuel D'utilisation

STEP :: 8 CHANGE ID CODES
An ID Code is the signal identification between the Remote Transmitter and Collar Receiver. Each is programd
in 1 of 2,000 ID Codes from the factory. The Remote Transmitter has the flexibility to program two or more
Remote Transmitters to the same ID Code, allowing them to control one Collar Receiver. There are 64
programmable ID Codes available.
TO MANUALLY PROGRAM A REMOTE TRANSMITTER'S ID CODE
1. Turn the Intensity Dial to V/T and then press and release the Mode Button on the back of your Remote
Transmitter. This does not change the mode, so the current mode will still be active after the ID change is
complete.
2. Once the Mode Button is released, the Transmitter Indicator Light will illuminate solid green and stay on
for 15 seconds.
3. While the green Indicator Light is on, turn the Intensity Dial to select the 1st digit of the ID and then press
and release the Side Button. The green Indicator Light will flash rapidly confirming selection.
4. Again, while the green Indicator Light is on, turn the Intensity Dial to select the 2nd digit of the ID and then
press and release the Side Button. The green Indicator Light will flash rapidly confirming selection. The
2nd digit is optional and, if not desired, wait until the green light turns off and refrain from pressing the
Side Button.
5. At the end of 15 seconds, or after the second press of the Side Button, the green Indicator Light will turn off
and the ID of the Remote Transmitter will be updated. At this point, the Remote Transmitter will be in the
same mode it was in prior to setting the ID.
6. Upon changing the ID Code, you will need to match the Collar Receiver to the Remote Transmitter (see
STEP 06).
NOTE: If you press the Side Button only once (skipping Step 4) the ID is still a two digit ID. The left digit is defaulted
to 1. For example, if you selected 6 in Step 3 and pressed the Side Button only once, the ID you get will be 16.
TO RETURN THE REMOTE TRANSMITTER TO THE FACTORY ID
1. Turn the Intensity Dial to V/T and then press and release the Mode Button on the back of your Remote
Transmitter. This does not change the mode, so the current mode will still be active after the ID change is
complete.
2. Do not press any buttons and wait until the green Transmitter Indicator Light turns off.
3. You will need to match the Collar Receiver to the Remote Transmitter (see STEP 06).

ACCESSORIES

To purchase additional accessories for your SportDOG
visit the Shop section on sportdog.com and search Parts & Accessories.
16
Remote Trainer, contact the Customer Care Centre or
®
WWW.SPORTDOG.COM