Beper 90.396 Manuel D'instructions page 10

Cotton Candy Maker Use instructions
INSTRUCTION FOR USE
FIRST USE
When used for the first time wash the bowl (1) and rotating reservoir (2) with warm water and wipe
all.
Locate the cotton candy make on a stable and horizontal surface.
Insert the bowl (1) on the motor (4).
Insert the rotating reservoir (2).
!ATTENTION!
A bad installation of the rotating reservoir (2) can alter the production of cotton candy or cause
excessive vibration.
USE
Connect the cord (7) on the socket and switch on the cotton candy maker using the switch on/off I/0
(5). Heat for about 5 minutes (the heating rods (3) lights up).
Switch of the cotton candy maker pressing the switch on/off (5) position 0.
Wait until the rotating reservoir (2) completely stops.
Put the suger inside the rotating reservoir (2) using the measuring cup (8).
!ATTENTION!
Do not put sugar inside the rotating reservoir when the device is operating.
Do not put too much sugar (please refer to the measuring cup, about 10 g of sugar), that could cause
noise and vibrations. Use white sugar. Do not use other ingredients.
Switch on the cotton candy maker using the switch on/off (5) on position I; the rotating reservoir (2)
start turning and heats with the heating rods (3).
!ATTENTION!
The rotating reservoir turns quickly and with high temperature; to avoid risks of injuries do never
touch with hands, spoons or other.
After 2-3 minutes sugar turns to cotton candy. Roll cotton candy on a wooden stick (to buy at the
supermarket).
Make the wooden stick rolls around the bowl (1).
When complete, switch off the cotton candy maker pressing the switch on/off (5) position 0.
When the cotton candy maker stops, wait until the rotating reservoir (2) completely stops before
adding sugar.
!ATTENTION!
The temperature of the rotating reservoir (2) remains hot for some minutes (about 15 minutes) after
the device stops.
10