Maintenance And Care; Environment - Festool SYSLITE STL 450 Notice D'utilisation Originale

Connecting the tripod and adapter [4]
► Fold out the tripod to the limit stop.
► Place the adapter in the required
position on the tripod up to the limit
stop.
► Turn the adapter until it clicks into
place.
Connecting the adapter and grazing
light [5]
Only fit the grazing light clip to the
marked area on the grazing light [5-1].
► Insert the back of the grazing light
into the grazing light clip.
Positioning the grazing light [6]
► Use the two rotary hinges to align
the grazing light in the direction of
the target surface.
► Adjust the height of the tripod.
8

Maintenance and care

NOTICE
Opening the device destroys the
seal (IP55 protection).
► Do not open the device.
► Replace a defective device.
The device is maintenance-free.
of its service life, the entire device must
be replaced.
Always clean the plastic cover on the
device using a soft, dry cloth and a mild
cleaning agent to prevent any damage.
Do not use solvents.
If the light
source has
reached the end
9

Environment

Do not dispose of the de­
vice in the household
waste! Recycle devices, ac­
cessories and packaging.
Observe applicable national
regulations.
EU only: In accordance with the Euro­
pean Directive on waste electrical and
electronic equipment and implementa­
tion in national law, used power tools
must be collected separately and hand­
ed in for environmentally friendly recy­
cling.
Information on REACH:
www.festool.com/reach
English
15