Fitting The Handle - EINHELL EBH 1100 Instructions De Service

Anleitung EBH 1100 08.11.2001 10:11 Uhr Seite 9
Chisel bits and drill bits may be flung out of the Maintenance
machine accidentally and cause serious injury:
Keep your machine clean at all times.
Before starting to work, always check that the
Never use caustic agents to clean the plastic
chisel or drill bit is properly locked in the chuck.
parts.
Examine the chuck regularly for signs of wear or
At the end of your work, to prevent dust deposits
damage.
you should use compressed air (max. 3 bar) to
Never start up a hammer tool until it pressed
clean out the ventilation slots with the motor
against a workpiece (wall, ceiling, etc.).
running.
When you are finished, unplug the hammer drill
Check the carbon brushes regularly (dirty or worn
from the electric supply and remove the chisel or
carbon brushes result in excessive sparking and
drill bit from the machine.
speed faults).
Always disconnect the hammer drill from the
If you discover any damage, use the enclosed
electric supply before you change a chisel or drill
drawing and parts list to establish exactly which
bit.
spare parts are required and order them from our
Protect your eyes and other workers from flying
Customer Service.
particles and splinters. Wear a helmet! Set up
partition walls!
Wear work gloves to protect fingers from bruising
and grazing.
Vibrations can injure the hand-arm system. Keep
exposure to vibrations as short as possible.
Functional principle behind the

Fitting the handle

electromagnetic hammer drill
You can screw the handle (8) in its mounting
thread on either the left or right-hand side of the
machine.
Resetting coil
Damping and hammering spring
Hammering coil
Switching system
Hammering piston
~230 V
Damping and
hammering spring
GB
9