Unpacking And Inspection; Items Supplied; Feature - Metcal BVX-200 Guide De L'utilisateur

WARNING!
Never cover exhaust openings.
WARNING!
Never cover all air inlet openings simultaneously.
Exception: One opening sealed off for single station operation.
WARNING!
This system is equipped with automatic reset overload protection, which may cause
the unit to restart automatically.
WARNING!
Observe general safety regulations for the handling of chemicals such as adhesives
and sealants. Observe the manufacturer's instructions as stated in the Material Safety
Data Sheet (MSDS).
While under warranty, the unit may be repaired only by an
Authorized Metcal Service Representative.

1.3 Unpacking and Inspection

Carefully unpack the Metcal Fume Extraction System and examine the items
contained in the Carton. Inspect the unit for any damage that might have
occurred in transit. If such damage is present, notify the carrier immediately.
Claims for damage must be made by the consignee to the carrier and should
be reported to the manufacturer.

1.4 Items supplied

1 Filter Unit with filters installed
1 Power Cord
Operating Manual
1
1.5 Features
•
On/Off switch with "soft-start" feature
•
Low noise level
•
High suction force and airflow
•
Compact and portable
•
HEPA Efficiency at 99.95% (Model BVX-201)
•
Deep-bed gas filter (Model BVX-203)
•
Connects to 50mm(2") or 63mm(2.5") hoses or exhaust arms
•
ESD safe housing
•
UL & CSA listed, CE certified
OK International ¥ Copyright © All Rights Reserved ¥ BVX-200 Rev 01-15-04
5