Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8634289
6.
Check the moisture filter instructions to determine when the disposable
moisture filter should be replaced. On average the filter will require
replacement every 7 to 10 spray applications or once a week.
It is recommended to install an air pressure regulator on the powder gun to
ensure the correct pressure is set at the tool as there may be pressure loss
between the compressor and the tool when using a long air hose.
ATTACH GROUND WIRE AND CLIP
The ground wire and clip provides a negative charge to the object being
powder coated.
1.
Loosen and remove the ground wire connector (H) from the screw.
2.
Place the end of the ground wire and clip (I) on the screw.
3.
Tighten the ground wire connector so the bare wire is firmly in contact with
the powder gun's body.
OPERATION
IMPORTANT! Always use dry, clean compressed air when using the powder
gun. Moisture can cause the powder to clump or interfere with the electric
charge that allows the powder to cling to the object being coated.
Proper handling of the powder gun will achieve the desired paint powder
coating. Read the paint powder instructions before applying.
The powder expelled from the powder guns' barrel has a positive charge due to
the friction. The powder will adhere to the part as the ground wire has created a
negative charge that attracts the positive charged powder.
The powder can be blown off with compressed air if a mistake is made, but the
charge will prevent the powder from falling off due to gentle movement. The
powder can be dislodged with mechanical methods. Avoid touching a powdered
section as skin oil can affect the powder.
The part will require curing once it is powdered. The curing process takes 20
minutes at 400 °F (205 °C).
8
Air Powder Coating Machine
For technical questions call 1-800-665-8685
V 4.0
Publicité
Table des Matières
