Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8634289
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Do not disassemble the powder coating gun. There are no serviceable
parts within it.
3.
Keep the tool handles clean, dry and free from oil/grease at all times.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
CLEANING
WARNING! Wear a dust mask rated grade P2 when cleaning the powder
coating gun or paint powder from the work area.
WARNING! Do not use a vacuum to clean up the plastic powder unless the
vacuum is equipped with an explosion-proof motor. The fine particles may
explode if exposed to an ignition source.
Clean the powder coating gun when finished for the day or changing powder
colours. Only use compressed air to clean the gun. Do not use solvents or
liquids. Clean the gun in the work area to contain the paint powder.
1.
Remove the powder canister (A). Replace the canister lid and tighten to
keep the powder dry.
2.
Start the compressor and adjust the air
pressure to the powder coating gun. Do not
exceed the maximum pressure (see
Specifications).
3.
Open the air pressure regulator (E) fully and
place your hand over the powder cup (B).
Point the powder coating gun into the work
area. Squeeze the trigger and blow the
powder out of the gun (Fig. 2)
14
Air Powder Coating Machine
For technical questions call 1-800-665-8685
V 4.0
Fig. 2
Publicité
Table des Matières
