Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V 4.0
IDENTIFICATION KEY
A
Powder Canister
B
Powder Cup
C
Gun Barrel
D
Trigger
E
Air Pressure Regulator
F
Disposable Moisture Filter
G
Air Fitting
H
Ground Wire Connector
I
Ground Wire and Clip (not shown)
ASSEMBLY & INSTALLATION
When this manual refers to a part number, it refers to the included Parts List.
INSTALL DISPOSABLE MOISTURE FILTER
WARNING! Do not exceed the air pressure rating on the moisture filter. If the
filter fails, it may cause an injury to the user or bystander.
The disposable moisture filter (F) will absorb moisture in the air line to keep the
air from the powder gun clean and dry.
1.
Wrap the external threads of the tool's male connector with sealant tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading threads unwrapped
for easier alignment.
2.
Wrap the male threads on the male end of the disposable moisture filter
with sealant tape. Install the included female air connector onto the filter.
3.
Screw female end of the moisture filter onto the male air connector of the tool.
a.
If installing a pressure gauge, install the moisture filter between the
gauge and the air hose.
4.
Connect the female connector to the air hose.
5.
Check that all connections are airtight at low pressure before using the tool.
Visit www.princessauto.com for more information
Air Powder Coating Machine
8634289
Fig. 1
7
Publicité
Table des Matières
