Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8634289
POWDER COATING THE PART
Read and follow the Personal Protective Equipment precautions in the Safety
section before proceeding.
1.
Tighten the air pressure regulator (E) to prevent air flow.
2.
Fill the powder canister (A) and invert the powder coating gun to screw the
canister onto the powder cup (B)
3.
Connect the powder coating gun to the air hose and start the compressor.
4.
Point the powder coating gun away from the parts and slowly unscrew the
air pressure regulator (E) to allow the air flow. The air pressure is correct
when the powder forms a soft cloud extending out roughly 8 inches from
the gun's barrel.
5.
Aim powder coating gun at the part from a distance of 7 or 8 inches and gently
move the gun back and forth to coat the part. Keep the gun level or pointing
down slightly. Do not point upwards. Begin in corners or areas where there
two components join together and then coat any exposed surface.
6.
Gently flip the object over by the hook and coat the other side.
a.
Repeat with other parts to prepare for a batch curing.
7.
Remove the ground clip if it is directly connected to the part and apply
powder to the bare spots until coated.
8.
If the powder coating job isn't acceptable, you can blow the powder off
with compressed air and begin again. Remove the clip if it is directly
connected to the part when removing the powder and then reattach it.
9.
Once the part is coated, move it to the curing oven.
a.
Move all parts of a batch to the curing oven. Move them one at a time
and close the door between each part to reduce heat loss.
10
Air Powder Coating Machine
For technical questions call 1-800-665-8685
V 4.0
Publicité
Table des Matières
