Using Side Av Connectors; Using Other Connectors; Remote Control Handset; Inserting Batteries - Telefunken TFE4202MDV Mode D'emploi

Using Side AV Connectors

You can connect a range of optional equipment to
your LED TV.
• For connecting a camcorder or camera , you should
use SIDE AV socket (side). To do this, you must use
the supplied video/audio connection cable. First,
plug single jack of the cable to the TV's AV IN socket
(side). Afterwards, insert your camera cable's (not
supplied) connectors into the plural part of the video/
audio connection cable. Colours of the connected
jacks should match. See illustration below.
• To listen the TV sound from headphones, connect
to the HEADPHONE jack of theTV.

Using Other Connectors

You can connect a range of optional equipment to your
TV. Possible connections are shown below. Note that
cables shown in the illustration are not supplied.
• For connecting to a device that has SPDIF support,
use an appropriate SPDIF cable to enable sound
connection.

Remote Control Handset

Inserting Batteries

• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the batteries from the remote control
handset when it will not be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

• Connect the power cord to the 220-240V AC, 50 Hz.
• Press STANDBY touch button. Then the standby
LED lights up.
• To switch the TV on from standby mode either:
• Press the " " button, P+ / P- or a numeric button on
the remote control.
• Press the -P/CH or P/CH+ touch button on the TV. The
TV will then switch on.
Note: If you switch on your TV via P+ / P- buttons on
the remote control or on the TV set, the programme that
you were watching last will be reselected.

To Switch the TV Off

• Press the " " button on the remote control or press
the " " touch button on the TV, so the TV will switch
to standby mode.
• To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such as
Standby Search, Over Air Download or Timer is active.
The LED can also blink when you switch on the TV from
standby mode.
- 51 -