Assembling The Control In The Interior - Graf 106850 Notice D'installation

5. Assembling the control in the interior

1.
The control must be installed in a dry and dust-
free interior. Two 8 mm holes must be drilled
into the wall for assembly.
3.
Position the compressor on the control. Connect
the compressor to the control unit pipe using the
90 Deg hose piece and hose clamps provided.
Plug the compressor plug into the control sock-
et.
5.
For further information please refer to the Con-
trol Unit operating manual.
5. Assembling the control in the interior
20 / 44
Secure the control to the wall using the dowels and
screws provided.
Connect the air hoses to the control's hose nozzles.
2.
4.