Operating Elements; Safety And Hazard Notices - VOLTCRAFT PS-1440 Notice D'emploi

Operating elements

(see fold-out page)
(1) Power unit for putting the device into operation (I=ON / 0=OFF)
(2) Power indicator
(3) Liquid crystal display (short „display", V = voltage, A = current)
(4) „COARSE" coarse settings controller for voltage
(5) „FINE" fine settings controller for voltage
(6) „PRESET" key for display switching to set the current limitation
(7) „OUTPUT" switch to switch on and off the DC output
(8) „OFF" light display for switched off DC output
(9) „TEMP." light display for active excess temperature switch-off (temperature limit is reached)
(10) „CV" light display for active voltage limitation
(11) „CC" light display for active current limitation
(12) High current connection terminal socket „Positive pole" (DC output)
(13) High current connection terminal socket „negative pole" (DC output)
(14) Connection socket „Ground potential"
(15) „FINE" fine settings controller for current
(16) „COARSE" coarse settings controller for current
(17) Grounded low-power connection for mains cable
(18) Fuse machine for the mains fuse

Safety and Hazard Notices

The warranty will be void in the event of damage caused by failure to observe
these safety instructions! We do not accept liability for damage to property or
injury to persons caused by misuse or non-compliance with the safety instruc-
tions!
• This device left the manufacture's factory in a safe and perfect condition.
We kindly request the user to observe the safety instructions and warnings contained in these oper-
ating instructions to preserve this condition and to ensure safe operation! Please pay attention to the
following symbols:
A triangle containing an exclamation mark indicates important information in these
operating instructions which are to be observed without fail.
The triangle containing a lightning symbol warns of danger of an electric shock or of the
impairment of the electrical safety of the device.
16