Annual Maintenance - Bayrol Automatic CL-pH Mode D'emploi

Maintenance
17
The indicated amount of maintenance is just the mini-
mum requirement. The frequency of maintenance
depends on the intensity of use.
The frequency of maintenance is determined by the
applicable, country-specific requirements! This may
result in considerably shorter maintenance intervals;
the relevant country-specific specifications and
standards must be observed.
Note:
Only use original BAYROL Technik components. The use
of third-party components can lead to malfunction
during operation. BAYROL Deutschland GmbH disclaims
all liability and warranty for this.
Hose replacement dosing pump:
30
MAINTENANCE PLAN
Weekly check:
– Make sure you keep your filter system in perfect condition.
– Check the values for pH and chlorine, preferably with a
BAYROL Technik Electronic Pool Tester.
– Carry out a visual inspection of the system for leaks in all
components, lines and hoses.

Annual maintenance:

– Replace the pH sensor and calibrate it.
– Replace the Redox-sensor and set the correct setpoint
mV. Make sure that the chlorine level in the pool water is
at the desired level.
– Replace the dosing pump hoses.
– Check the respective injection valves for pH and chlorine
and renew them if necessary.