Message List - Bayrol Automatic CL-pH Mode D'emploi

Operation
14

Message list

All messages are listed in the message list. Additional in-
formation is displayed here for each message. In addition,
Automatic offers wizards for most messages that will
Cl-pH
guide you step by step to the solution.
If the problem cannot be solved despite following all the
instructions, please contact your dealer.
Calibration – adjustment of the measured values
Please note that you must remove the sensors from their
holders when calibrating the pH- and redox-sensors using
the buffer solutions provided. Make sure that not too much
water can escape during this process.
Follow the instructions on the display.
RECOMMENDATION
To avoid taking out the sensors, you can perform the calib-
ration with the pool water.
Please measure the pool water values with a photometer
(e.g. BAYROL Electronic Pooltester).
REMOTE ACCESS
To set up convenient remote access to your Automatic
please proceed as follows:
– Create a user account at www.bayrol-poolaccess.com.
– Register your Automatic
will need the serial number of your device, which you will
find on the type plate on the side of the housing.
– You will be shown a 6-digit web portal PIN. Please make
a note of this PIN, it must be entered once later in your
device.
– Now tap on the WiFi icon in the home screen of your
Automatic
and connect it to the desired WLAN in the
Cl-pH
„WLAN (WiFi) Connection" menu.
– Now connect your Automatic
entering the previously noted web portal PIN in the
„App & web portal connection" menu.
Now your Automatic
created user account and can be operated from the web
portal.
28
in your user account. You
Cl-pH
to the web portal by
Cl-pH
is visible in your previously
Cl-pH
If you would also like to operate your Automatic
veniently via app on your smartphone, please proceed as
follows:
– In the device list of the web portal: Press app link button
– A QR code with URL (https://bayrol-poolaccess ...) will
now be displayed to you
– Please note the App Link Code displayed, it will be
used later to enter it in the app.
,
Cl-pH
– You have called up the webportal on your PC:
Scan the QR-Code with your Smartphone or enter the
URL in the Smartphone-Browser.
– You have called up the webportal on your Smartphone:
Simply tap directly on the URL.
You are using a smartphone
with Android operating
system:
– You are using a smartpho-
ne with Android operating
system:
– Tap the „Add to Home
Screen" button to install
the app.
– In the „Install App" dialog,
confirm the installation.
– Now the app is installed. Close the browser of your
smartphone and launch the app from the home screen.
When the app is started for the first time, a short guided
sequence is run through. In this sequence, the app is
linked to your Automatic
code.
con-
Cl-pH
You are using a smartphone
with iOS operating system:
– Tap the icon („Share")
and select the „To Home
Screen" option.
– In the „To Home Screen"
dialog, select the „Add"
option.
by entering the app link
Cl-pH