Bayrol Automatic CL-pH Mode D'emploi page 29

Additionals options
15
KIT Smart&Easy Connector Flow – Flow monitoring
The optionally available KIT Smart&Easy Connector
Flow allows you to use the sensors for pH and ORP, as
well as the injection valves for pH-Minus Liquid Domestic
(pH-Plus Liquid) and Chloriliquide in a particularly con-
venient and easy-to-maintain location.
The Smart&Easy Connector also includes an integrated
paddle flow switch, which is connected to the
Automatic by means of a simple plug-in connec-
Cl-pH
tion.
KIT Level Automatic Double – Canister monitoring
The optionally available KIT Level Automatic Double
enables direct monitoring of the fill level of the canis-
ters for pH-Minus Liquid Domestic or pH-Plus Liquid
and Chloriliquide by means of two easy-to-handle
suction lances. When the canister is empty, a mes-
sage is shown on the display.
The KIT replaces the supplied foot filters and can thus
be easily connected to the intended Level pH and
Level Cl connection and mounted on the correspond-
ing liquid containers with the help of a screw cap.
KIT Temperatur Automatic – Temperature
monitoring
With the optionally available KIT Temperature Auto-
matic it is possible to measure the temperature of the
pool water.
The temperature sensor can be integrated into the
circulation system at a suitable point for temperature
measurement by means of its supplied tapping
clamp.
Winterizing
16
In colder temperatures, it is recommended to take the
Automatic out of operation (e.g. during the winter
Cl-pH
period).
The following instructions show you how to winterise
your pool:
In case of active winterizing (pool filter system remains
in operation)
– Stop the filter pump.
– Rinse the pump hoses with clear water.
– Empty the pump hoses.
– Remove the sensors from their holders and store them in
their container, which is preferably filled with KCl solution
or also with clean pool water. Store the sensors in a dry
and cool but frost-free place.
– Insert ½" plugs instead of the sensor holders.
– Store the canisters for pH-Minus Liquid Domestic or
pH-Plus Liquid and Chloriliquide in a dry and cool but
frost-free place.
In case of passive wintering (filter system of the pool
is switched off).
– Stop the filter pump.
– Rinse the pump hoses with clear water.
– Empty all pump hoses.
– Close and empty the filter system. Make sure that the
entire pool circulation system is drained as much as
possible.
– Remove the sensors from their holders and store them in
their container, which is preferably filled with KCl solution
or also with clean pool water. Store the sensors in a dry
and cool, but frost-free place.
– Store the canisters for pH-Minus Liquid Domestic or
pH-Plus Liquid and Chloriliquide in a dry and cool but
frost-free place.
29