Troubleshooting - Snapper XD 1696871 Guide D'utilisation

TROUBLESHOOTING

PROBLEM
The snow shovel does
not start.
The motor is on, but
the rotor does not turn.
The snow shovel
leaves a thin layer.
POSSIBLE CAUSE
The battery is not charged.
The lock-out button or trigger
switch were not used properly.
Battery is too cold.
The battery is not fully inserted
into the housing.
The belt is damaged.
The scraper is worn.
SOLUTION
Charge the battery by following the procedures in the battery and
charger manual or this manual.
Press and hold the lock-out button, while holding the lock-out
button, press the switch trigger (See Figure 7).
Remove battery from snow shovel. Place battery on charger and
allow to charge for 10 minutes. Remove from charger and install in
Snow shovel for use.
Check if the battery is fully inserted into the housing.
Call for technical service.
Replace the scraper (See Figure 9-10).
19