Assembly; Assembly For Kf Titrations - Metrohm 6.5613.000 Mode D'emploi

1. Assembly

Use the ECO titration equipment together with the 703 Ti Stand. It
is best to feed the 703 Ti Stand with a separate 11 V power
adapter (and not directly from the Titrator).
Ordering numbers for the power adapter:
220...240 V
110...117 V

1.1 Assembly for KF titrations

see picture on the front page.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Set 6.1808.100 distributor onto the titration vessel lid and fix
11. Connect the rinsing nozzle with the left aperture of the dis-
12. Connect the tubing of the rinsing solution at the side of the
6.5613.000 Titration Equipment
6.2117.030
6.2119.030
Fix titration vessel on the stand rod.
Set the 6.2740.030 rinsing nozzle into the left rear aperture:
Put 6.2730.030 nipple, then E.301.0022 O-ring onto the
rinsing nozzle and screw it into the aperture.
Cut 2 cm of 6.1543.120 aspirating tip and place it in the right
front aperture: Set 6.2730.030 nipple, then E.301.0022 O-
ring onto the aspirating tip and screw it into the aperture.
Close the small apertures with 6.2730.030 stoppers.
Close the big aperture to the right with 6.2730.060 nipple
and 6.2709.090 stopper.
Screw 6.2730.070 stopper into the left aperture and insert
6.0338.100 KF electrode without O-ring.
Fill drying tube with drying agent (e.g. molecular sieve, or-
dering number 6.2811.000) and screw it into the middle ap-
erture using 6.2730.070 stopper.
Set 6.2730.020 septum stopper into the middle aperture in
the front.
Remove stopper of the rear middle aperture and insert buret
tip with titrating agent.
Place stirring bar in the titration vessel and fix the vessel to
the lid. Take care that the 6.1454.030 gasket is straight.
Adjust the height of the titration vessel.
it at the stand rod.
tributor using 6.1805.010 tubing.
Close the 2 remaining apertures of the distributor with
6.1446.040 stoppers.
distributor.
1. Assembly
20