Battery And Charger - Poulan Pro PPB40T Manuel D'instructions

and any other condition that may affect
its operation. A guard or other part that is
damaged should be properly repaired or
replaced by an authorized service center
unless indicated elsewhere in this manual.
• For use only with PPB402AH, PPB404AH
batteries and PPB40CGR charger.
• Do not open or mutilate the battery.
Released electrolyte is corrosive and may
cause damage to the eyes or skin. It may
be toxic if swallowed.
• Exercise care in handling batteries in order
not to short the battery with conducting
materials such as rings, bracelets, and
keys. The battery or conductor may
overheat and cause burns.
SERVICE
Tool service must be performed only by
qualified repair personnel using only identical
replacement parts. This will ensure that the
safety of the tool is maintained. Service
or maintenance performed by unqualified
personnel may result in a risk of injury. Please
call 1-855-378-6903 for customer support.

BATTERY AND CHARGER

Do not dispose of the battery in a fire. The
cell may explode. Check with local codes for
possible special disposal instructions.
DANGER
risk of fire, explosion and danger of electric
shock or electrocution:
• DO NOT probe the charger with conductive
materials. The charging terminals hold
120V.
• If the battery pack case is cracked or
damaged, DO NOT insert into the charger.
Replace the battery pack.
• DO NOT charge these battery packs with
any other type of charger.
• DO NOT allow liquid inside the charger.
• DO NOT try to use the charger for any
other purpose than what is presented in
this manual.
WARNING
battery pack in rain or in wet conditions. Do
not immerse the tool, battery pack, or charger
in water or other liquid.
• Do not allow the battery pack or charger
to overheat. If they are warm, allow them
to cool down. Recharge only at room
temperature.
SAFETY RULES
:
To avoid serious injury,
:
Do not charge the
• Do not cover the ventilation slots on top of
the charger. Do not set the charger on a
soft surface. Keep the ventilation slots of
the charger clear.
• Do not allow small metal items or material
such as steel wool, aluminum foil, or other
foreign particles into the charger cavity.
• Unplug the charger before cleaning and
when there is no battery pack in the cavity.
• Do not place the battery charger or the
battery pack in the sun or in a warm
environment. Keep at normal room
temperature.
• Do not try to connect two chargers
together.
• The battery pack cells may develop a small
leak under extreme usage or temperature
conditions. If the outer seal is broken and
the leakage gets on your skin:
-Use soap and water to wash immediately
-Neutralize with lemon juice, vinegar, or
other mild acid.
• If battery fluids gets in your eyes, flush
immediately with water for at least 15
minutes. Get immediate medical attention.
WARNING
UNDERSTAND ALL INSTRUCTIONS. Failure
to follow safety rules listed below may result
in electric shock, fire, and/or personal injury.
• Do not abuse the cord. Never use the
cord to carry the tool. Never pull on the
cord to remove plug from the outlet. Keep
cords away from heat, oil, sharp edges,
or moving parts. Replace damaged cords
immediately. They may create a fire. Do
not use if damaged.
• Do not place the charger where the power
cord might be stepped on, tripped on, or
subjected to damage.
• A battery-operated tool with integral
batteries or a separate battery pack must
be recharged only with the specified
charger for the battery. A charger that may
be suitable for one type of battery may
create a risk of fire when used with another
battery.
• Use a battery-operated tool only with the
specifically designated battery pack. Use
of any other batteries may create a risk of
fire.
6
:
READ AND