emerio AF-124772 Mode D'emploi page 10

Problem
The device does not work. The
displays on the control panel does
not switch on.
The fuse in the
distributor (fuse box) is triggered.
The food has not been cooked
evenly.
The food is slightly burnt.
Chips made from fresh potatoes
are not crispy.
During use, an unpleasant smell
or smoke is detected.
Error messages E1 or E2
TECHNICAL DATA
Operating voltage: 220-240V~ 50/60Hz
Power: 1800W
Possible cause
The door is not closed properly.
The mains plug is not inserted
correctly in the plug socket.
The plug socket is defective.
No mains voltage is predent.
The overheating protection has
been triggered.
electical Too many devices connected to
the same circuit.
Different items of food with
different cooking times have been
prepared at the same time.
Items of food which require
different cooking temperatures
have been prepared at the same
time.
The set cooking time was too short
or the temperature was too low.
The rotating basket or baking rack
is overfilled.
The items of food are piled on top
of one after another.
The selected temperature is too
high or the cooking time is too
long.
The potatoes contain too much
water.
The device is dirty.
The device is being used for the
first time.
Too much oil or grease.
The sensor is defective.
Close the door.
Push the mains plug into the plug
socket as far as it will go.
Try another plug socket.
Check the fuse of the electical
distributor (fuse box).
Pull the mains plug out of the plu g
socket and allow the device to cool
down completely. Then try again.
Reduce the number of devices in
the circuit.
Place food with a longer cooking
time in the device first, and then
add ingredients with a shorter
cooking time later.
Prepare
defferent cooking temperatures
one after another.
Increase the cooking time or
temperature.
Reduce the amount of food.
Spread the food and mix it around
from time to time.
Reduce
cooking time.
Cut the potatoes into narrow
pieces. Dab the potato pieces dry
with some kitchen towel and then
trickle a little cooking oil over
them.
Follow the instructions in the
section
maintenance".
A smell often develops when new
devices are first used. The smell
should disappear once the device
has been used several times.
Remove excessive oil or grease.
Contact
department.
- 9 -
Solution
items of food with
the temperature
"cleaning and
the customer service
or