GE GFD85 Guide De L'utilisateur Et Instructions D'installation page 6

Getting started
Features and appearance will vary.
A
B
A
B
A
B
Power
A
Press to "wake up" the display. If the display is active, press to put the dryer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Start and Pause
B
Press Start to begin the cycle. NOTE: The door must be closed for the dryer to start the cycle. Pressing Start
again will pause the cycle, the Start light will blink and "Pause" will display.
To continue the cycle, press Start again.
Display and Status Lights
C
The display shows the approximate time remaining until the end of the cycle and the dryer cycle status
(Sense, Drying, Damp and Cool).
In addition, the display will show:
(WiFi)
Controls
Check Filter
Check Vent
6
D
D
D
Will allow your appliance to communicate with your smartphone for remote appliance
monitoring control and notifications.
The dryer is locked - will blink once if you press any pad or turn the cycle knob.
The Check Filter light will stay on for 15 seconds after the cycle stops.
The Check Vent light indicates an issue has been found due to reduced airflow from a possible
blocked or restricted vent. Checking and/or cleaning the vent system is recommended. See the,
"Check Vent" light is on in the Troubleshooting Tips section.
C
F E
C
F E
C
F E
F
F
F
49-3000206 Rev 1