SERVICE PROCEDURES
Continued
SPARK TRANSFORMER
1. Remove access panel.
2. Locate and disconnect white, black and
orange wires from spark transformer.
3. Remove screw holding spark transformer to
base. Remove sheet metal nut on transformer
and install on new transformer. Discard spark
transformer.
4. Install new spark transformer. Position new
spark transformer in same manner as old
transformer.
5. Connect white, black and orange wires to new
spark transformer. Connect wires to correct ter-
minals as noted in Wiring Diagram, page 10.
6. Replace access panel.
113959-01B
Spark Plug
Figure 9 - Removing Spark Plug Nut
and Spark Plug (Heater may vary from
www.desatech.com
3/4" Hex
Head Nut
illustration)
Rear Head
9