Searching For A Device Code - Bose 3-2-1 II Serie Notice D'utilisation

Controlling Other Audio Devices
AUX AUX
AUX AUX
36
To set up the remote to control your VCR or PVR (such as Tivo or Replay TV)
1. Turn on both the 3•2•1 system and your VCR or PVR.
2. Press and hold the AUX button until the remote LED is lit (about five seconds).
3. On the remote keypad, enter the four-digit device code for your VCR/PVR. The LED will
turn off temporarily as you press each key.
4. Check that the LED turns off after the code is entered. If the LED blinks, the code is
invalid. Try again.
5. Point the remote at your VCR or PVR and press the AUX On-Off button. If your VCR or
PVR does not respond, go back to step 2 and try other codes. If you are still unsuccess-
ful, see "Searching for a device code" on page 36.

Searching for a device code

Use this method if you do not know the device code for a device.
Note: This is a very time-consuming process. Use it as a last resort.
To set up the remote to control your TV
1. Turn on both the 3•2•1 system and your TV.
2. Press and hold TV until the remote LED is lit (about five seconds).
3. Alternately press Channel
4. Press Enter. Check that the remote LED turns off.
5. Point the remote at your TV and press TV On-Off. If your TV does not respond, go back
to step 2 and try again.
and TV On-Off until your TV turns off.