Making System Connections; Connecting The Acoustimass Module To The Media Center; Connecting The Speakers To The Acoustimass Module - Bose 3-2-1 II Serie Notice D'utilisation

System Setup

Making system connections

Figure 6
Acoustimass module-to-
media center connection
Figure 7
Speaker cable-to-
Acoustimass module
connection
12
CAUTION: Do not plug the Acoustimass
components are connected.
Note: If additional audio cables or longer cables are needed to make these connections, contact
Bose Customer Service. Refer to the list of offices included in the product carton.

Connecting the Acoustimass module to the media center

Plug one end of the Acoustimass module cable into the Acoustimass Module jack on the rear
of the media center (Figure 6). Plug the other end of the cable into the input (
rear of the Acoustimass module.
Note: The jacks for the Acoustimass module cable are keyed so that the cable connectors only plug
in one way. Make sure that the arrow on the connector body faces up when plugging in the cable.
Media center
rear panel

Connecting the speakers to the Acoustimass module

1. Insert the single-plug end of the speaker cable into the SPEAKERS jack on the rear
panel of the Acoustimass module (Figure 7). Tighten both screws on the plug.
Acoustimass
module cable
® module into an AC power (mains) outlet until all the
Acoustimass
module cable
Acoustimass
module input
jack
) jack on the
Acoustimass
module input
jack
Speaker
cable