Replacing The Lamp - Sony VPL-FH500L Guide De Référence Rapide

Replacing the Lamp

Replace the lamp with a new one if a message displayed on the projected image or the LAMP/
COVER indicator notifies you to replace the lamp.
The projector incorporates two lamps. Before replacement, check which lamp is to be replaced.
Use an LMP-F330 projector lamp (not supplied) for replacement.
Caution
• The lamp remains hot after the projector is
turned off. If you touch the lamp, you may
burn your finger. When you replace the
lamp, wait for at least an hour after
turning off the projector for the lamp to
cool sufficiently.
• Do not allow any metallic or inflammable
objects into the lamp replacement slot after
removing the lamp, otherwise it may cause
electrical shock or fire. Do not put your
hands into the slot.
• If the lamp breaks, contact qualified
Sony personnel. Do not replace the lamp
yourself.
• When removing the lamp, be sure to pull it
out straight, by holding it by the specified
part. If you touch a part of the lamp other
than the specified part, you may be burned or
injured. If you pull out the lamp while the
projector is tilted, the pieces may scatter if
the lamp breaks any may cause injury.
Before starting
The projector incorporates two lamps.
Check the number of flashes of the LAMP/
COVER indicator. This enables you to be
informed of a lamp to be replaced.
Flashes three times: Replace Lamp 1.
Flashes four times: Replace Lamp 2.
Flashes five times: Replace both Lamp 1
and Lamp 2.
14
GB
Replacing the Lamp
1
Turn off the projector, and disconnect
the AC power cord from a wall outlet.
2
When the lamp has cooled
sufficiently, loosen the two screws of
the lamp cover on the side panel (
slide the lamp cover slightly to the rear
by the tabs ( ), then open the lamp
2
cover ( ).
3
Lamp cover
Screws
Lamp 1
Lamp 2
),
1
Tab