Replacing The Lamp - Sony VPL-PX41 Guide De Référence Rapide

Replacing the Lamp

When the lamp has burnt out or dims, or
"Please replace the LAMP." appears on the
screen, replace the lamp with a new one. Use
LMP-P260 Projector Lamp as the
replacement lamp. The lamp life varies
depending on conditions of use.
Caution
The lamp becomes a high temperature after
turning off the projector with the I / 1 key. If you
touch the lamp, you may scald your finger.
When you replace the lamp, wait for at least an
hour for the lamp to cool.
Notes
• If the lamp breaks, consult with qualified Sony
personnel.
• Pull out the lamp by holding the handle. If you
touch the lamp, you may be burned or injured.
• When removing the lamp, make sure it remains
horizontal, then pull straight up. Do not tilt the
lamp. If you pull out the lamp while tilted and if
the lamp is broken, the pieces may scatter,
causing injury.
1
Turn off the projector, and disconnect
the AC power cord from the AC
outlet.
Note
When replacing the lamp after using the
projector, wait for at least an hour for the
lamp to cool.
2
Place a protective sheet (cloth) beneath
the projector. Turn the projector over so
you can see its underside.
Note
Be sure that the projector is stable after
turning it over.
3
Open the lamp cover by loosening a
screw with the Phillips screwdriver.
Note
For safety sake, do not loosen any other
screws.
4
Loosen the three screws on the lamp unit
with the Phillips screwdriver. Pull out
the lamp unit by the handle.
Handle
Note
The screws have washers. Do not remove the
screws, just loosen them.
5
Insert the new lamp all the way in until it
is securely in place. Tighten the screws.
Fold up the handle.
Notes
• Be careful not to touch the glass surface of
the lamp.
• The power will not turn on if the lamp is not
secured properly.
6
Close the lamp cover and tighten the
screws.
Note
Do not tighten the screws too much. Doing so
could damage some of the internal
components of the projector.
7
Turn the projector back over.
8
Connect the power cord and turn the
projector to standby mode.
Replacing the Lamp
9
GB