DELTACALOR MONZA Notice D'utilisation Et D'installation page 62

8. Press the key until the device network
configuration is complete.
The device does not heat enough
• The device could be set in ECO MODE or ANTI FREEZE. You should set the COMFORT
mode or increase the setting temperature
The device heats continuously
• Check the position where the heater is installed: it should be far from any air flow.
• Check to be set the proper temperature.
If the problem persists you should interrupt the power supply to the heater and wait
for one minute at least before turning it back on. If the problem persists again, please
contact the technical assistance.
TROUBLESHOOTING
VIDEO TUTORIAL
Follow the instruction manual for pairing the Wi-Fi thermostat or
watch the video tutorial linked to the QR code here at the side.
[ 62 ]
• You can be in Eco mode, Frost protection
mode, or Auto mode with a reduction im-
posed by the power manager. Switch to
Permanent Comfort mode or increase the
setting.
• Check that your appliance is not near an
air intake.
• Check that the set temperature has not
been changed