DELTACALOR MONZA Notice D'utilisation Et D'installation page 52

Heater options and settings
To select the setting configuration menu, press the
sing the key.
To exit the settings menu, the user must choose the setting
"EXIT" and press the
key for a few seconds.
1. Place a thermometer in the room, at the same distance from the floor as the thermostat.
Check the actual room temperature after 1 hour.
2. Enter this value in the calibration settings menu using the keys
value.
3. Press to confirm the calibration.
Exit the settings menu
If you press the key
return to the SETTINGS menu.
. key. Another way to exit the settings menu is to press and hold the
Calibrating the temperature sensor:
Calibration must be done after 1 day of use with the same configu-
ration temperature, as described below:
ITCS - Intelligent Temperature Control System
(adaptive start heating in AUTO mode)
This function is described in "Special functions".
This setting activates or disables this function.
Preset value: Yes (function activation)
Other options: No
Automatic detection of an open window
This function is described in "Special functions". This setting
allows you to enable or disable this function.
Preset value: Yes (function activation)
Other options: No
you can exit the USER settings menu and
. Lkey. The configuration is done by pres-
[ 52 ]
and to enter the actual