On-Board Systems - OTC OBD II Scan Tool Mode D'emploi

On Non-CAN vehicles the Tool displays:
‰ test data (test ID)
‰ maximum value (MAX)
‰ test measurements (MEAS)
‰ minimum value (MIN)
‰ status (STS)
‰ measurements and specification values are hexadecimal
numbers (i.e., $1A, $FE, $11.)
‰ module (MOD)
On CAN vehicles the Tool displays:
‰ Test performed. The test performed can be $## if test is not
defined. Refer to vehicle service manual for details.
‰ Measured values and units of measure (such as volts, amps,
seconds).
‰ Status of monitor test data.
‰ Module ID where the monitor test data came from.

On-Board Systems

The On-Board Systems test allows the Tool to control operation of
vehicle components, tests, or systems.
9 Some manufacturers do not allow tools to control vehicle
systems. A vehicle not supporting an on-board system is
identified by a message displayed when selected.
9 Refer to the appropriate vehicle service manual for on-board
systems instructions.
9 After selecting On-Board Systems, a list of on-board
systems and components available for testing are shown on
the display.
OR
16