Long Pid Names; State Obd Check (Emissions) - OTC OBD II Scan Tool Mode D'emploi

Long PID Names

Long PID Names allows the user to enable/disable the tool scrolling
the complete PID name on the bottom line of the display while viewing
Live Data or viewing Freeze Data.
‰ From the System Setup menu, use the ▲UP or ▼DOWN
arrow keys until Long PID Names is highlighted, then press
ENTER.
‰ Select ON or OFF as desired using the ▲UP or ▼DOWN
arrow keys, then press
r e t u r n t o S y s t e m Setup.

State OBD Check (Emissions)

The State OBD Check function is used to display a basic status of the
vehicle's OBD system.
The State OBD Check function has the following areas:
‰ MIL STATUS ON or OFF
‰ Number of Codes Found
‰ Number of Monitors OK
‰ Number of Monitors Inc
‰ Number of Monitors N/A
9 State OBD Check should be done with the key on engine
running (KOER) due to showing MIL status.
9 The number of codes found are both Confirmed and
Permanent codes. Pending codes are not included.
9 The number of Monitors that are either OK, INC or NA are
only Since DTCs Cleared and not This Drive Cycle.
9 Refer to Read Codes and I/M Monitors for more detailed
information about the results.
ENTER to save or BACK to
12