Icons; Connect The Tool - OTC OBD II Scan Tool Mode D'emploi

Icons

The following icons may appear on the display:


CONFIRMED
PENDING
PERMANENT
# of #
Mod $##

Connect the Tool

To connect the Tool to the vehicle:
1. Locate the OBD II connector under the steering column.
If the connector is not there, a label should be there indicating
the whereabouts of the connector. For more information on OBD
II connectors, go to http://www.obdclearinghouse.com/oemdb.
2. If necessary, remove the cover from the vehicle connector.
3. Turn the ignition switch to the ON position. Do not start the
engine.
4. Plug the OBD II Connector attached to the Tool into the vehicle
connector.
The Tool automatically reads Codes and I/M Monitors and dis-
plays the data. When done viewing data, press  BACK key to
return to Diagnostic Menu.
Indicates additional information is available on next
screen by using the  ERASE key.
Indicates additional information is available on pre-
vious screen by using the  READ key.
Confirmed codes are reported when a component
is indicating a malfunction is present.
Pending codes are reported when a problem occurs
during the current or last completed drive cycle.
Permanent codes are a special type of confirmed
code that only the vehicle can erase.
Appears only when viewing codes. Indicates code
sequence and quantity (code # of n). For example,
if you see 2 of 9 you are looking at the 2nd of 9
codes reported by the computer module.
Appears only when viewing codes. Indicates the
computer module that reported the code.
Indicates that the READ and ERASE hot keys
are active.
6