Drive Cycle Monitor; View Freeze Data; Vehicle Information; System Setup - OTC OBD II Scan Tool Mode D'emploi

Drive Cycle Monitor

The Drive Cycle Monitor function is very similar to the I/M Monitors
though the Drive Cycle Monitor is used to view REAL TIME operations
of the Emissions System on OBD II vehicles.
9 Drive Cycle Monitor continuously updates as the vehicle
reports operations of the Emission System.
9 Refer to the vehicle service manual for how to perform a drive
cycle on your specific vehicle.
9 Drive Cycle Monitor will only show the monitors that are inc
(incomplete). When all monitors are complete the Tool will
display a message.
See I/M Monitors for more information.

View Freeze Data

Displays a snapshot of operating conditions at the time the Diagnostic
Trouble Code was created. See PID Definitions for more information.

Vehicle Information

The Vehicle Information function allows the Tool to request the vehicle's
VIN number, calibration ID(s) which identifies software version in vehicle
control module(s), calibration verification numbers (CVN(s)), and In-use
Performance Tracking (IPT).
Vehicle Information function applies to model year 2000 and newer
OBD II compliant vehicles.
NOTICE
The Vehicle Information function is not supported by all
vehicles. Also, not every vehicle supports every piece of
information (for example, CVN, IPT, VIN).

System Setup

System Setup allows:
• Display contrast to be changed
• Tool information to be viewed
• Display to be checked
• Operation of the keypad to be checked
• Memory of the Tool to be checked
• Language to be changed
• Units of measure to be changed
• Long PID Names to be enabled/disabled
11