Fein BLK1.3TE Mode D'emploi page 24

OBJ_BUCH-0000000077-001.book Page 24 Wednesday, July 18, 2012 8:10 AM
en
24
Repair and customer service.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
Exchangeable parts
If required, you can change the following
parts yourself:
Application tools
Service.
Have maintenance carried out
WARNING
only through qualified person-
nel. Incorrectly mounted leads and compo-
nents can cause serious injuries. Have the
required service carried out only through a
FEIN customer service agent.
The current spare parts list for this power
tool can be found in the Internet at
www.fein.com.
Cleaning.
Prior to any cleaning or main-
WARNING
tenance, disconnect the power
tool from the power supply in order to avoid
accidents.
When using in environments
WARNING
with conductive dust in the air,
such as when cutting metals, this dust can
settle in the interior of the power tool. This
can impair the total insulation of the power
Warranty and liability.
The warranty for the product is valid in accordance with the legal regulations in the country
where it is marketed. In addition, FEIN also provides a guarantee in accordance with the FEIN
manufacturer's warranty declaration.
All accessories described or shown in this instruction manual will not be included with your-
power tool.
Environmental protection, disposal.
Packaging, worn out power tools and accessories should be sorted for environmental-friendly
recycling.
For further information, please contact your specialist shop.
tool. Therefore, regularly blow out the interior
of the power tool from outside via the ventila-
tionopenings with dry, oil-free compressed
air; always wear eye protection when doing
this. For additional protection, connect a
residual current device (RCD) on the line side.
Do not attempt to clean
CAUTION
clogged or dirty ventilation
openings of the power tool with pointed
metal objects; use nonmetal tools or objects
if necessary.
Do not use cleaning agents
CAUTION
and solvents that can cause
damage to plastic parts. These include: Gas-
oline, carbon-tetrachloride, chloric solvents,
ammonia and domestic cleaning agents that
contain ammonia.
If the supply cable of this
CAUTION
power tool is damaged, it
must be replaced by a specially prepared cable
available through the FEIN customer service
center.
Lightly grease the sliding surfaces
between die holder and punch.