Know Your Product; Operation; Prior To Initial Operation - SPARKY SM 1212CE Notice Originale

recommendations,
sanding paper. Larger sanding paper ex-
tending beyond the sanding pad presents
a laceration hazard and may cause snag-
ging, tearing of the disc or kickback.
V - Know your product
Before using the power tool, familiarize your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
POWER TOOL BASIC PARTS fOR ALL
INTENDED APPLICATIONS
1. Bearing bed
2. Front handle
3. Spindle lock button
4. Driving machine
5. ON/OFF switch
6. Clamp
7. Lock screw
8. Spindle
9. Spring
10. Dust extraction port
11. Guard
12. Brush ring
13. Seeger circlip
14. Support flange
15. Support disc
16. Tightening nut
17. Flexible pad
18. Sandpaper
19. Electronic speed regulator
20. Support flange
21. Lightweight diamond disc *
22. Support bush
23. M14 flexible backing pad *
24. Vacuum cleaner hose *
25. Sanding pad for dry fine sanding *
26. Pin spanner
* The additional accessories shown in the illus-
trations or described in the text are not included
in the delivery.
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
Sandpaper up to Ø200 mm for SM 1212CE;
Sandpaper up to Ø225 mm for SMA 1212CE;
Abrasive net discs Ø200 mm for SM 1212CE;
Abrasive net discs Ø225 mm for SMА 1212CE
Original instructions
when selecting Diamond discs with various grit max. Ø7"
(max 0,5 kg);
Sanding pads for dry fine sanding max. Ø7"
with hook-and-loop fastening;
M14 flexible backing pad with hook-and-loop
fastening.
VI - Operation
These power tools are supplied from single-
phase alternating current mains only. They are
double insulated according to EN 60745-1,
IEC 60745-1 and can be connected to grounded
or not grounded sockets. This power tool is ra-
dio suppressed in compliance with EMC Direc-
tive 2004/108/EC.
The basic use of this power tool is for sand-
ing plaster coated ceilings and walls, for sand-
ing smoothed drywalls and for removing paint,
wallpaper and adhesive remnants by means of
sandpaper.
When using an appropriate tool the machine can
be used for sanding stone and concrete walls.
This power toll is not designed for CUTTING!
WARNING: Using this power tool with
accessories differing from the described here-
with may cause accidents during operation.
The possibility to connect an operating tool
does not mean the machine is designed to be
used with it.
Using this power tool with accessories differ-
ing from the described herewith and all risks
for your health resulting from such use are en-
tirely on YOUR OWN RESPONSIBILITY!

PRIOR TO INITIAL OPERATION

▪ Make sure the power supply voltage corre-
sponds to the value indicated on the name
plate with technical data of the tool.
▪ Always check the position of ON/OFF switch.
The power tool must be connected to the
power supply socket only when this switch is
in OFF position. If the plug is connected to
a receptacle while the power switch is in the
ON position, the power tool will start operat-
ing immediately, which could cause a serious
accident.
▪ Make sure that the cord and the plug are in
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
7
EN