Pando PHC-943 Manuel D'utilisation page 76

INOXPAN S.L.
3. Turn Turn the control dial to position
4. Set the temperature to 90º C.
5. Program a duration of 4 minutes on the timer.
6. After 4 minutes, an alarm will sound and the oven will stop heating.
7. Turn the control dial to position
8. Wait for about 20 minutes for the interior of the oven to cool.
Do not open the oven door until the SCS function is complete.
The cooling cycle is necessary for the function to work properly.
9. Any traces of dirt and excess water can now be removed from the oven with the damp cloth.
The SCS function takes place at a low temperature. However, cooling times can vary depending
on the room temperature.
Before touching the inside surface of the oven, make sure that it has cooled properly.
If a deeper clean is required after using the SCS function, use neutral detergents and non-
abrasive sponges.
.
.
EN - 16