FRESKO V8 Mode D'emploi page 24

1. Make sure that the outer drawing joint on the right rear side of the machine is properly installed back
into the machine before the machine is used or after the outer drawing is used (push it to the bottom and
keep the calibration line on the outer drawing head basically flush with the edge of the shell).
2. Connect the plug of the machine correctly to the power socket, and the machine will be automatically
started for inspection until the aperture of the button panel is fully lit, and the machine is ready for work.
How to Make a Bag from a FRESKO Vacuum Seal Roll:
After using up the sheet bag we gave you as a gift, you can buy the roll bag for use if necessary.
*Note: vacuum bag bent face down
300 mm
(11.8Inches)
22
(1) Select a vacuum bag with a width of no more
than 300mm(11.8inches), pull the roll bag and cut
the roll bag with scissors (Figure 1)
(2) Put the cut roll bag into the vacuum machine
smoothly, and leave a distance of at least 40mm
between the opening of the vacuum bag and the
sealing of the vacuum bag.When the "seal"
indicator light is off, press the "seal" button to
complete the seal (Figure 2).You can take the bag
out of the vacuum passage.