Specifications; Mounting Precautions (For Sharp Dealers And Service Engineers) - Sharp PN-L705H Manuel D'installation

Model
Power requirement
Operating temperature *
Operating humidity
Power consumption
Dimensions (excluding protrusions) inch (mm) Approx. xx (W) x xx (D) x xx (H) (xx x xx x xx)
Weight
* When using the monitor laying flat on a surface (when the monitor is tilted more than 20 degrees upward from the perpendicular in relation to
a level surface), use the monitor at a temperature between 41°F (5°C) to 86°F (30°C).
Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP.
In such cases, please check the temperature condition specified by the optional equipments.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.

Mounting Precautions (For SHARP dealers and service engineers)

• When installing, removing or moving the monitor, ensure that this is carried out by at least 4 people.
• Be sure to use a wall-mount bracket designed or designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials
such as plaster / thin plastic board / wood before starting installation.
This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor.
Install by the most suitable method for the material and the structure.
• To attach a VESA-compliant mounting bracket, use M6 screws that are 5/16 inch (8 mm) to 3/8 inch (10 mm) longer than the
thickness of the mounting bracket.
• Do not use an impact driver.
• After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount.
• Do not use any screw holes other than VESA holes for installation.
• When moving this monitor, hold with the handles or at the sides of this monitor, and hold the top and bottom of this monitor.
Do not grasp the screen, monitor corner, tray, speaker, or speaker cover. This may cause product damage, failure, or injury.
• If you need to temporarily place the monitor on a table or other surface during installation, spread a thick soft cloth on the
table to prevent damage to the screen and table.
• Prior to repacking or removal, remove the tray and speaker covers.
• When using the monitor laying flat on a surface (when the monitor is tilted more than 20 degrees upward from the
perpendicular in relation to a level surface), consult an authorized SHARP dealer because there are some specific mounting
conditions.
8
E

Specifications

PN-L705H
AC 100 V - 240 V, 3.2 A, 50/60 Hz
41°F to 95°F (5°C to 35°C)
20% to 80% (no condensation)
xx W
lbs. (kg) Approx. xx (xx)
5/16 - 3/8 inch (8-10 mm)
Screws (M6)
Mounting bracket
Monitor mounting