Inventum HZ46G Mode D'emploi page 13

• The electrical and magnetic fields emitted by this foot warmer may
interfere with the function of a pacemaker. However, they are still well
below the limits: electrical field strength: max. 5000 V/m, magnetic
field strength: max. 80 A/m, magnetic flux density: max. 0.1 millitesla.
Please therefore consult your doctor and the manufacturer of your
pacemaker before using this foot warmer.
• Do not pull, twist or make sharp bends in the cables.
• If they are not positioned properly, there may be a risk of becoming
entangled in, being strangled by, tripping over, or stepping on the cable
and controller of the foot warmer. The user must ensure that excess
lengths of cable, and cables in general, are safely routed.
• Please check this foot warmer frequently for signs of wear and tear
or damage. If any such signs are evident, if the foot warmer has been
used incorrectly or if it no longer heats up, it must be checked by the
manufacturer before being switched on again.
• Under no circumstances should you open or repair the foot warmer
(including the accessories) yourself because faultless functionality
can no longer be guaranteed thereafter. Failure to observe this will
invalidate the warranty.
• If the mains connection cable of this foot warmer is damaged, it must
be disposed of. If it cannot be removed, the foot warmer must be
disposed of.
• When this foot warmer is switched on:
– Do not place any sharp objects on it
– Do not place any heat sources, such as hot water bottles, heat pads
or similar, on it
• The electronic components in the controller warm up when the foot
warmer is in use. For this reason, the controller must never be covered
or placed on the foot warmer when it is in use.
• It is essential to observe the information relating to the following
chapters: Operation, Cleaning and maintenance, Storage.
• If you should have any questions about using our devices, please
contact our Customer Services department.
13
English •