Hand-Held Operation - Triton MOD001 Instructions D'utilisation Et Consignes De Sécurité

OPTIONAL TEMPLATE GUIDE BUSHES
An optional guide bush adaptor with seven
different template guide bushes are available for
template routing.
This accessory kit (part
no.TGA150) also includes
a Chip Collector and Table
Winder, and is available
through your local Triton
retailer.

HAND-HELD OPERATION

• Always use both hands to control the router and
ensure your workpiece is
securely clamped to prevent any
movement during operation.
• Never operate the
router free-hand
without some form of
guidance. Guidance
can be provided by
a bearing guided
cutter, the fence
guide supplied or a straight edge (eg. a batten
clamped to your work as shown above).
• Always feed against
direction of
cutter
rotation
(clockwise, as
indicated by the
arrows on the
router base).
• Do not operate the router upside down unless
securely mounted in a well guarded router table
(eg. Triton brand)
THE BASE ASSEMBLY
The Extended Baseplate (24) supplied with the
Triton Router provides greater stability when using
bearing guided cutters along
an edge.
Place one hand on the
long end of the base,
holding it down onto your
work, and grip the router
handle, furthest away,
with your other hand.
MOF001 Manual_new1.indd 9
Extended Baseplate and Fence
1. To fit the extended baseplate (24) loosen the
mounting knobs (19) approximately 10mm (
up the coach bolt.
2. Position the extended baseplate onto the base
of the router with the heads of the coach bolts
beneath the keyhole slots in the baseplate.
The router can
be mounted with
the long overhang to
the left or to the right
depending on where the
support is required. For
the edge work, locate the
power switch on the short overhang side of the
base.
3. Push the mounting knobs (19) until the bolt
heads locate into the keyholes, then slide
the extended baseplate until the bolts locate
against the ends of the keyhole slots. Tighten
the knobs firmly.
4. To fit the fence (20)
loosen the fence knobs
a few turns and slide the
fence along the tracks
on the base. Lock at
the desired setting by
tightening both fence
knobs.
When routing trenches some distance in from
an edge, fit the fence to the long end of the
base.
⁄ ")
3
8
Hand-Held Operation 9 9
27/10/09 10:06:02
GB