Brush Replacement; Power Cord Replacement - Triton MOD001 Instructions D'utilisation Et Consignes De Sécurité

SERVICE
• Any damage to the router should be repaired
and carefully inspected before use, by qualified
repair personnel. Service or maintenance
performed by unqualified personnel could result
in a risk of injury.
• Servicing should only be carried out by
authorised Triton Repair Centres using original
Triton replacement parts. Follow instructions
carefully and refer to "Trouble-shooting" for
problem identification and advice. Use of
unauthorised or faulty parts may create a risk
of electric shock or injury.
• Triton Precision Tools will not be responsible for
any damage or injury caused by unauthorised
repair of the router or by mishandling of the
tool.

BRUSH REPLACEMENT

The carbon brushes are a consumable item which
should be inspected periodically and replaced
when worn. Failure to do so may result in damage
to the motor.
1. With the router disconnected from power,
unscrew the Brush Caps (8) located on the front
and rear of the motor.
2. Remove the brushes by pulling carefully on the
protruding springs.
3. If either of the brushes
is worn to less than
6mm long, they must
both be replaced
using genuine Triton
replacement brushes
- available from
Authorised Triton Repair Centres.

POWER CORD REPLACEMENT

If the supply cord needs replacing, the
task must be carried out by the manufacturer, the
manufacturer's agent,
or an authorised service centre in order
to avoid a safety hazard.
MOF001 Manual_new1.indd 11
GB
Service
11
27/10/09 10:06:03