Fire Hazard - InSinkErator WASH-1 Manuel D'installation, D'entretien Et D'utilisation

6. FILL TANK &
THEN CONNECT POWER
SCALDING HAZARD
Steam and hot water can spit forcefully from the
spout if the temperature is set too high at startup.
A
Turn on the cold water supply.
Brass Nut
Ferrule
Lift handle to warm position.
Brass Insert
Leave faucet open for at least 2 minutes to fill the
tank. Water will flow from spout during the
2 minute fill time.
A GFCI outlet within 30" (75 cm) of the faucet is
required under the sink. Do not use an extension
cord set with the dispenser.
B
Water will be cold at first.
Allow 12-15 minutes for water to reach target
Gurgling or hissing is normal during the
Check all connections to ensure they are tight and
that there are no leaks.
Plug in water tank.
Brass Nut
Ferrule

FIRE HAZARD

temperature.
initial heating cycle.
7. ADJUSTING THE THERMOSTAT
SCALDING HAZARD
Do not allow output water temperature to exceed
125°F/52°C.
Incoming Water Temp
> 45°F/ 7°C
≤ 45°F/ 7°C
Instant warm water temperature depends on
incoming water temperature and tank settings.
Start with dial set at the lowest setting.
Turn dial clockwise to increase temperature.
After adjusting, allow 12 - 15 minutes for water
to re-heat at the new setting.
Lift faucet and use thermometer to measure
temperature of water output.
Repeat as necessary to attain desired warmth.
9
Tank Setting
Dial factory preset at this setting