Equipment Required; Electric Shock Hazard - InSinkErator WASH-1 Manuel D'installation, D'entretien Et D'utilisation

EQUIPMENT REQUIRED:

Drill
T-fitting
Dedicated control valve
Adjustable wrench
Phillips and flat blade screwdrivers
Pencil
Tape measure
Level
Thermometer
These instructions are separated into main sections,
indicated by numbers, and subsections, indicated by
capital letters. The manual is setup this way to allow you
to take a break at any point after completing a section or
subsection without affecting the installation process.
Provides a step-by-step narrative describing
1
the installation step, with tick boxes that can be
marked as you progress through the installation.
Contains simple illustrations that provide visual
2
instruction to support the narrative.
WARNINGS, CAUTIONS and NOTICES that will
3
require your attention during the step.
Required Tools/Materials
How To Use This Instruction Manual
EQUIPMENT YOU MAY NEED:
Anchors for drywall
Hole saw
If you need to cut a mounting hole in your stainless
steel sink, you may need a 1¼" (32 mm) - 1½" (38 mm)
hole saw made for cutting stainless steel or a hole
punch. Consult a professional before drilling into a
surface other than stainless steel.
A
2
NOTICE
Do not pinch or break copper tubing.
Do not distort the last 1" (25mm) of tubing.

ELECTRIC SHOCK HAZARD

Appliance must be grounded.
6
Basin nut wrench
Hole punch
■
Unpack tap
1
components.
■ On a firm, flat
surface, carefully
straighten the
copper tubing.
3