InSinkErator WASH-1 Manuel D'installation, D'entretien Et D'utilisation page 8

3. MOUNTING THE TANK
NOTICE
PROPERTY DAMAGE
Tank must be located within 16" (40 cm) of faucet
and within 30" (75 cm) or less of a GFCI outlet.
DO NOT extend plumbing or electrical lines.
A
Identify locations for the faucet and tank.
Check to make sure there is proper clearance for
faucet handle to be fully opened.
Check to make sure counter is not too thick.
Make sure there is a GFCI outlet under the sink.
B
Leave ¼" (0.64 cm)
for hanging tank.
1
Screws provided are for use in wood studs or cabinets only.
Use wall anchors (not supplied) for installation into drywall.
Pre-drill 1/8" (3 mm) pilot holes at marks.
Turn screws into pre-drilled holes, leaving
1/4" (6 mm) exposed.
Hang the tank on the screws.
Tighten the screws with only 1/2 turn clockwise.
2
2
3
Tank must be mounted
level to ensure
proper operation.
2
3
4. CONNECT FAUCET TO TANK
PROPERTY DAMAGE
• Pinched or blocked water lines may cause
damage to the dispenser tank.
• Check to make sure tubes are connected properly
and are pushed down as far as possible.
A
Without depressing the gray button, place the
snap-connect fitting at the end of the blue 1/4"
(6 mm) tube onto the left fitting on the tank,
pushing until it clicks into place. (1)
Slip the flexible white 7/16" (11 mm) tube over
barbed middle fitting and slide down approximately
1/2" (13 mm). (2)
Slip the clear 5/16" (8 mm) tube over the far right
smooth fitting and slide down approximately
1/2" (13 mm). (3)
Visually check for pinched or crimped tubes.
Hose clamps are not needed for any of the connections.
5. FINAL WATER CONNECTION
PROPERTY DAMAGE
Join remaining tube to cold water supply only.
SCALDING HAZARD
Do NOT connect to water supply exceeding
60°F/16°C.
A
Shutoff value
(not included)
3/8" (10 mm)
Supply line to flow
control
fitting
It is recommended that the water connection be
made using a shutoff valve (not supplied).
Where plumbing codes permit, a saddle valve
(not supplied) can be used to supply water to
the faucet. Follow the directions for "self-piercing
attachments" included with the valve.
8
NOTICE
(1) (2) (3)
Brass Nut
Ferrule
Brass Nut
NOTICE
5/16" (8 mm)
cold water supply
Flow
control
fitting
Brass Insert
Ferrule
Brass Insert