Important Safety Information - InSinkErator WASH-1 Manuel D'installation, D'entretien Et D'utilisation

• Ensure all tubing and fittings are secure and free
of leaks.
• Do not install using rigid piping. System intended for
use with plastic water lines (such as PEX tubing,
PE tubing, PP tubing).
• Do not install this system if any of the quick connect
collets are missing from the filter head or Y-Quick
Connector. Contact an authorized InSinkErator
Service agent if collets are missing from any fittings.
• Important: Do not allow the unit to continuously boil.
NOTICE
SAVE THESE INSTRUCTIONS
• Use this water heater only for its intended use as
described in this manual.
• This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given
supervision or instruction concerning use of the
appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made
by children without supervision.

IMPORTANT SAFETY INFORMATION

A potentially hazardous situation, which, if not avoided, could result in death or serious injury.
Potentially hazardous situation, which, if not avoided, could result in minor
or moderate injury.
Notice is used to address practices not related to personal injury.
• Regularly inspect the system. If there are signs of
water leakage, turn off the water supply and contact
an authorized InSinkErator Service agent.
• A drain pan, plumbed to an appropriate drain or
outfitted with a leak detector, should be used in
those applications where any leakage could cause
property damage.
• For questions or concerns, please contact an
authorized InSinkErator Service agent (see back
page for contact information).
• Do not operate this product if it has been or appears
to be damaged in any manner or after the product
malfunctions, or is dropped. Return the complete
product immediately to your retailer or dealer for
inspection.
• If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
• Do not connect to water supply exceeding 60°F/16°C.
3